Lenson Montgomery Dam No.1 Reservoir Report

Last Updated: December 5, 2025

Lenson Montgomery Dam No.1, located in Hale County, Alabama, was completed in 1969 with a primary purpose of 'Other'.


°F

°F

mph

Wind

%

Humidity

Summary

This private dam stands at a hydraulic height of 19 feet and a structural height of 22 feet, with a length of 300 feet. It has a storage capacity of 76 acre-feet and a maximum discharge of 1700 cubic feet per second. The dam is situated on the TR-Little Brush Creek and is under the jurisdiction of the Mobile District of the US Army Corps of Engineers.

With a significant hazard potential and a condition assessment that is 'Not Rated', Lenson Montgomery Dam No.1 poses a potential risk to the surrounding community on HWY.51. Despite not being state-regulated or inspected, this earth-type dam serves a crucial purpose in managing water resources in the area. The dam does not have an Emergency Action Plan prepared or updated, raising concerns about the readiness to handle any unforeseen events.

As water resource and climate enthusiasts continue to monitor the impact of dams on the environment, the case of Lenson Montgomery Dam No.1 highlights the importance of regular inspections and risk assessments to ensure the safety and integrity of such structures. With its location in a high-risk area and limited regulatory oversight, there is a need for increased attention to the maintenance and emergency preparedness of this dam to prevent any potential disasters.

Year Completed

1969

Dam Length

300

River Or Stream

TR-LITTLE BRUSH CREEK

Primary Dam Type

Earth

Hydraulic Height

19

Nid Storage

76

Structural Height

22

Hazard Potential

Significant

Nid Height

22
       
Seasonal Comparison

Weather Forecast

Dam Data Reference

Condition Assessment

Satisfactory
No existing or potential dam safety deficiencies are recognized. Acceptable performance is expected under all loading conditions (static, hydrologic, seismic) in accordance with the minimum applicable state or federal regulatory criteria or tolerable risk guidelines.
Fair
No existing dam safety deficiencies are recognized for normal operating conditions. Rare or extreme hydrologic and/or seismic events may result in a dam safety deficiency. Risk may be in the range to take further action. Note: Rare or extreme event is defined by the regulatory agency based on their minimum
Poor A dam safety deficiency is recognized for normal operating conditions which may realistically occur. Remedial action is necessary. POOR may also be used when uncertainties exist as to critical analysis parameters which identify a potential dam safety deficiency. Investigations and studies are necessary.
Unsatisfactory
A dam safety deficiency is recognized that requires immediate or emergency remedial action for problem resolution.
Not Rated
The dam has not been inspected, is not under state or federal jurisdiction, or has been inspected but, for whatever reason, has not been rated.
Not Available
Dams for which the condition assessment is restricted to approved government users.

Hazard Potential Classification

High
Dams assigned the high hazard potential classification are those where failure or mis-operation will probably cause loss of human life.
Significant
Dams assigned the significant hazard potential classification are those dams where failure or mis-operation results in no probable loss of human life but can cause economic loss, environment damage, disruption of lifeline facilities, or impact other concerns. Significant hazard potential classification dams are often located in predominantly rural or agricultural areas but could be in areas with population and significant infrastructure.
Low
Dams assigned the low hazard potential classification are those where failure or mis-operation results in no probable loss of human life and low economic and/or environmental losses. Losses are principally limited to the owner's property.
Undetermined
Dams for which a downstream hazard potential has not been designated or is not provided.
Not Available
Dams for which the downstream hazard potential is restricted to approved government users.