Rattle & Snap #18 Reservoir Report

Last Updated: December 13, 2025

Rattle & Snap #18, located in Maury, Tennessee, is a local government-owned dam on the TRIBSUGAR FORK river.


°F

°F

mph

Wind

%

Humidity

Summary

Built in 1980, this earth dam stands at a hydraulic height of 34.5 feet and has a structural height of 38.5 feet, with a total length of 5550 feet. The dam has a maximum storage capacity of 511 acre-feet and a normal storage of 350 acre-feet, covering a surface area of 43 acres and draining an area of 0.08 square miles.

Despite being classified as having a low hazard potential and not currently rated for condition assessment, Rattle & Snap #18 presents a moderate risk level (3) according to available data. The dam does not have any outlet gates or locks, and its spillway type is uncontrolled, with a spillway width of 0 feet. While it has not been inspected in recent years, the dam undergoes inspection every 5 years, suggesting a commitment to monitoring its safety and functionality.

For water resource and climate enthusiasts, Rattle & Snap #18 serves as a noteworthy structure in Tennessee, contributing to the region's water management and flood control efforts. With its historical significance and strategic location, this dam represents a vital piece of infrastructure that warrants ongoing attention and evaluation to ensure its continued effectiveness and safety in the face of changing environmental conditions.

Year Completed

1980

Dam Length

5550

River Or Stream

TRIBSUGAR FORK

Primary Dam Type

Earth

Surface Area

43

Hydraulic Height

34.5

Drainage Area

0.08

Nid Storage

511

Structural Height

38.5

Outlet Gates

None

Hazard Potential

Low

Nid Height

39
       
Seasonal Comparison

Weather Forecast

Dam Data Reference

Condition Assessment

Satisfactory
No existing or potential dam safety deficiencies are recognized. Acceptable performance is expected under all loading conditions (static, hydrologic, seismic) in accordance with the minimum applicable state or federal regulatory criteria or tolerable risk guidelines.
Fair
No existing dam safety deficiencies are recognized for normal operating conditions. Rare or extreme hydrologic and/or seismic events may result in a dam safety deficiency. Risk may be in the range to take further action. Note: Rare or extreme event is defined by the regulatory agency based on their minimum
Poor A dam safety deficiency is recognized for normal operating conditions which may realistically occur. Remedial action is necessary. POOR may also be used when uncertainties exist as to critical analysis parameters which identify a potential dam safety deficiency. Investigations and studies are necessary.
Unsatisfactory
A dam safety deficiency is recognized that requires immediate or emergency remedial action for problem resolution.
Not Rated
The dam has not been inspected, is not under state or federal jurisdiction, or has been inspected but, for whatever reason, has not been rated.
Not Available
Dams for which the condition assessment is restricted to approved government users.

Hazard Potential Classification

High
Dams assigned the high hazard potential classification are those where failure or mis-operation will probably cause loss of human life.
Significant
Dams assigned the significant hazard potential classification are those dams where failure or mis-operation results in no probable loss of human life but can cause economic loss, environment damage, disruption of lifeline facilities, or impact other concerns. Significant hazard potential classification dams are often located in predominantly rural or agricultural areas but could be in areas with population and significant infrastructure.
Low
Dams assigned the low hazard potential classification are those where failure or mis-operation results in no probable loss of human life and low economic and/or environmental losses. Losses are principally limited to the owner's property.
Undetermined
Dams for which a downstream hazard potential has not been designated or is not provided.
Not Available
Dams for which the downstream hazard potential is restricted to approved government users.