Campbell Lake Reservoir Report

Last Updated: December 5, 2025

Campbell Lake, located in Fort Jones, California, is a privately owned reservoir that serves as a vital water supply source for irrigation and other purposes.


°F

°F

mph

Wind

%

Humidity

Summary

Built in 1929, this Earth dam stands at a height of 19 feet and has a storage capacity of 350 acre-feet. The lake covers a surface area of 35 acres and is fed by the Shackleford Creek, with a drainage area of 0.5 square miles.

Managed by the California Department of Water Resources, Campbell Lake is regulated, inspected, and enforced to ensure its safety and reliability. Despite its low hazard potential, the dam is regularly assessed for its fair condition, with the last inspection conducted in June 2020. The dam's emergency action plan status and risk management measures are yet to be fully documented, highlighting the ongoing efforts to enhance preparedness and safety protocols for this essential water resource.

For water resource and climate enthusiasts, Campbell Lake stands as a testament to the intricate balance of maintaining infrastructure for water supply while safeguarding against potential risks. With its historical significance and strategic location within Siskiyou County, this reservoir serves as a critical component of the region's water management system, reflecting the ongoing commitment to sustainable resource utilization in the face of changing environmental conditions.

Year Completed

1929

Dam Length

65

Dam Height

19

River Or Stream

Shackleford Cr

Primary Dam Type

Earth

Surface Area

35

Hydraulic Height

14.9

Drainage Area

0.5

Nid Storage

350

Hazard Potential

Low

Nid Height

19
       
Seasonal Comparison

Weather Forecast

Dam Data Reference

Condition Assessment

Satisfactory
No existing or potential dam safety deficiencies are recognized. Acceptable performance is expected under all loading conditions (static, hydrologic, seismic) in accordance with the minimum applicable state or federal regulatory criteria or tolerable risk guidelines.
Fair
No existing dam safety deficiencies are recognized for normal operating conditions. Rare or extreme hydrologic and/or seismic events may result in a dam safety deficiency. Risk may be in the range to take further action. Note: Rare or extreme event is defined by the regulatory agency based on their minimum
Poor A dam safety deficiency is recognized for normal operating conditions which may realistically occur. Remedial action is necessary. POOR may also be used when uncertainties exist as to critical analysis parameters which identify a potential dam safety deficiency. Investigations and studies are necessary.
Unsatisfactory
A dam safety deficiency is recognized that requires immediate or emergency remedial action for problem resolution.
Not Rated
The dam has not been inspected, is not under state or federal jurisdiction, or has been inspected but, for whatever reason, has not been rated.
Not Available
Dams for which the condition assessment is restricted to approved government users.

Hazard Potential Classification

High
Dams assigned the high hazard potential classification are those where failure or mis-operation will probably cause loss of human life.
Significant
Dams assigned the significant hazard potential classification are those dams where failure or mis-operation results in no probable loss of human life but can cause economic loss, environment damage, disruption of lifeline facilities, or impact other concerns. Significant hazard potential classification dams are often located in predominantly rural or agricultural areas but could be in areas with population and significant infrastructure.
Low
Dams assigned the low hazard potential classification are those where failure or mis-operation results in no probable loss of human life and low economic and/or environmental losses. Losses are principally limited to the owner's property.
Undetermined
Dams for which a downstream hazard potential has not been designated or is not provided.
Not Available
Dams for which the downstream hazard potential is restricted to approved government users.